This controller has been designed for use in radio control aircraft and to support continuous currents of up to 25 amps when using 2- to 3-cell Li-Po battery packs and up to 4 sub-micro servos. The ESC features a lightweight plastic case with exposed, finned heat sinks for both the motor drive MOSFETs and, unlike many controllers, the BEC regulators give you a more reliable and powerful power supply for your servos.
Features
- Up to 25-amp continuous current with proper air flow
- Finned heat sinks for both the motor drive MOSFETs and dual BEC regulators to support up to 4 sub-micro servos
- Programmable motor braking
- Safe power-arm mode prevents accidental starts
- Programmable low-voltage cutoff with settings for 2-cell Li-Po (6V), 3-cell Li-Po (9V) or 70% of battery starting voltage
- Programmable throttle input range (1.1–1.9 ms or Auto Select)
- Auto motor shut down if signal is lost or there is interference
- Programmable timing—2 user-selectable ranges for use with a large variety of brushless motors
- Pre-wired connectors—E-flite EC3 on battery input and 3.5mm female gold bullets on motor output leads
- Soft start
In Depth
- Brake: Yes - Programmable
- Continuous Maximum Current: 25A
- Input Connector Types: 16AWG with E-flite EC3 connector
- Output Connector Types: 16AWG with 3.5mm Female Gold Bullet Connectors
- Momentary Peak Current: 30A (15 sec)
- Length: 1.9 in (48mm)
- Width: 1.1 in (28mm)
- Height: 0.4 in (11mm)
- Weight: 1.2 oz (32g)
- Cells w/BEC: 2-3S Li-Po or 6-10 Ni-MH/Ni-Cd
