Based on the popular Hangar 9 Ultra Stick, the E-flite Mini Ultra Stick comes 95% prebuilt from balsa and light-ply and is covered in genuine UltraCote. At the heart of the Mini Ultra Stick’s fun factor are two firewall options that let you use a wide variety of motor sizes, types and brands. This along with the ample clearance for larger props that its tall, lightweight aluminum landing gear provides gives the Mini Ultra Stick huge performance potential. You can push the envelope even further by adding the optional split quad-flaps.
Features
- Perfect transitional airplane for advancing pilots who want to learn aerobatics and for sport flyers who want easy comfortable sport flyer
- 95% factory-built; get flying in 2 hours or less
- Lightweight balsa and plywood construction
- Two firewall options to use a variety of motor sizes, types & brands
- Includes molded firewall stick mount
- Control surfaces have factory-installed hinges and control horns
- Bolt-on tail requires no gluing and secures with two lock nuts
- Optional quad-flap configuration
- Tough, lightweight aluminum landing gear that's factory-assembled and tall enough to accommodate larger prop sizes
- Covered in genuine Hangar 9 UltraCote
- Great match for E-flite Park 450 Outrunner Brushless Motor
- Easy access top battery hatch
- Design based on Hangar 9’s popular line of Ultra Sticks
In Depth
- Wingspan: 38.75 in (985mm)
- Overall Length: 34 in (865mm)
- Wing Area: 325 sq in (21 sq dm)
- Flying Weight: 22 - 25 oz (625 - 710g)
- Motor Size: Park 400 Inrunner or Park 450 Outrunner
- Radio: 4-channel or greater (7-channel for quad flaps)
- Servos: 4 sub-micros (6 sub-micros for quad flaps)
- Trim Scheme Colors: UltraCote Fluourescent Blue, Flame Red, Transparent Red & White
- CG (center of gravity): 2.25 in (57mm) behind the leading edge
- Prop Size: 10x7 - 11x7
- Hardware Included: Yes
- Speed Control : 20A Brushless
- Recommended Battery: 2100 mAh 3-Cell 11.1V Li-Po
- Flaps: Yes (optional)
- Control Throw (Ailerons): 1/2 in (15mm) Up/Down Low Rate or 5/8 in (19mm) High Rate
- Control Throw (Elevator): 9/16 in (18mm) Up/Down Low Rate or 7/8 in (23mm) High Rate
- Control Throw (Rudder): 7/8 in (23mm) Right/Left Low Rate or 1-1/4 in (32mm) High Rate
- Approx. Flying Duration: 10-20 minutes
- Scale: Park Flyer
- Approx. Assembly Time: 1-2 hours
- Gear Ratio: 6.5:1 when using Park 400 Brushless Inrunner
Required
-
Brushless Motor
Brushless ESC
4+ Ch Radio
4 Sub-micro Servos
Servo Extensions & Y-harness
4 to 6-Ch Receiver
Li-Po Battery
Li-Po Charger
CA
Propeller
